Technical specification
ELECTRONICS
| Power: | 250 W RMS per channel into 8 Ω 30 W pure class A 1000 W RMS on lower impedance |
| Sensitivity: | 1 V or 2 V RMS |
| Bandwidth: | 0 Hz to 120 KHz, +0/-0.5 dB |
| Crosstalk: | Not related for mono amplifiers |
| Signal-to-noise ratio: | Typically 110 dB ASA “A” weighted |
| THD+N: | < 0.03% |
| Input type: | XLR balanced RCA unbalanced |
| Input impedance: | 88 KΩ on balanced input 44 kΩ on unbalanced input |
| DC filter: | Toggle switch allows to cut the DC of incoming signals |
| Protection: | Overheating > +70° C (158° F) |
| Remote in and out: | 1/8″ jacks in and out can trigger the amplifier on or off from a Nagra MPS or a home automation system |
| Power cord: | IEC C19 this is not the standard IEC but a larger 20A plug |
MONITORING
Nagra modulometer, precision measurement tool
Clipping LED
Intensity can be adjusted, from off to full bright
GENERAL
| Consumption: | 1200 W max less than 1 W in standby and Auto mode |
| Weight: | 56 Kg (123.4 lb) each unit |
| Size: | Width 23.8 x Height 64.4 x Deepness 54.2 cm (9.3 x 25.3 x 21.3″) |
| Operating range: | 90 – 110 V or 110 -132 V or 180 – 264 V a.c. 50 – 60 Hz |